3D Printer Equipment – Ultimakers


Bert and Ernie are single extrusion Ultimaker 2+ printers available at Main library.

ultimaker 3

The Ultimaker 3 is a dual extrusion 3D printer available at Grand library.

3D printing is free and easy!

Check out this quick 2 minute demo from our library staff!


The library uses 2.85mm PLA filament in an assortment of colors. Filament colors may vary by location and are available while supplies last. Colors include pink, orange, yellow, green, blue, and white.




The 3D prints pictured above were printed from files found on ThingiVerse.com.

Need Project Ideas?

To print an existing design, view the following websites:

To create your own designs, visit the following:

Be sure to save your files as either .STL or .OBJ for printing at the library. If your print will take longer than 2 hours, then please reserve a 3D printer on http://libcal.ssf.net/equipment?lid=40

Troubleshooting Prints

If your prints are not coming out as intended visit the following website for tips & tricks:

If you have any further questions about the Ultimaker or 3D printing, our TLC staff will gladly assist you upon your visit!